Skip to main content
Free Delivery Over £125 exc. VAT
Free Expert Help & Advice
Free Training
Decarbonising Heating & Hot Water

EUP11RSVERT - Morco EUP Room Sealed Water Heater - for Vertical flues

SKU: EUP11RSVERT
View spares for this appliance
View now
£640.92 (Inc. VAT)
£534.10 (Ex. VAT)

In Stock

Free Delivery Over £125 exc. VAT

Delivery details
Adding to basket... The item has been added
The EUP11RSVERT is the equivalent to the F11EL. It is EUP compliant with the same power output as the F11EL. It has electronic ignition and is a room sealed, fan flued water heater which means it can be installed in a wide range of locations.
The flues and fitting kits for this new heater are different from those used on the F11EL. The EUP11RSVERT can only be flued vertically using the RSF045SP flue. This cannot be adapted in the field to fit a horizontal flue. The fitting kit required is the PKE.
A conversion document to make the replacement of an F11EL with an EUP11RSVERT more straightforward is contained within the fitting/conversion kit. This can also be found in the downloads section below.
This appliance can also be used as a replacement for an open flued appliance but we would recommend taking a look at our help article on this topic.
This appliance may be suitable for installation in boats, catering trailers, glamping units and shepherd’s huts. In all cases, a flue and an electricity supply, along with an earth, are necessary. For boats, all installations must comply with the Boat Safety Scheme requirements.
This appliance is not suitable for motorhomes.
We would always advise speaking to a Gas Safe engineer with the required qualifications who will be carrying out the installation to make sure they are happy it complies with any relevant regulations.
Please see below for more technical information.
Flow rate: 8 Litres per minute approx. at 35 degree temperature rise
Dimensions: H 658 W 304 D 238
Fully EuP compliant
Gas Type: LPG
Room Sealed
Fan flued
Can only be flued vertically (RSF045SP) – for a horizontally flued appliance please see the EUP11RS
Electronic ignition
Mains electricity required
Can be used on a 12v system with a small inverter
Must be fitted by a Gas Safe registered engineer
£640.92 (Inc. VAT)
£534.10 (Ex. VAT)

In Stock

Free Delivery Over £125 exc. VAT

Delivery details
Adding to basket... The item has been added