News

 

EUP6 Water Heater

Published: 2nd March 2020

We are pleased to announce the launch of our EUP6 water heater. New EuP regulations came into force in September 2018 which state that water heaters must have lower Nitrogen Oxide (NOx) emissions. This water heater is fully EuP compliant, meeting all of the requirements for these regulations.

This is an EUP compliant direct replacement for the D61B, D61E and MP6. The flue diameter is the same at 90mm, so if you are replacing a D61 you can use the existing flue.

The EUP6 has a piezo ignition and is not available with an electronic ignition.

The EUPFK fitting/conversion kit will be required in order to fit the water heater as the gas and water connections are different to those on the D61 and MP6. Please note that this is the same fitting/conversion kit as the one required for an EUP11, however, we will also be offering and EUPFK10 for use with the EUP6 which allows for a 10mm gas connection, if needed.

The usual Morco spares, advice and support will be provided.

A conversion document to make the replacement of a D61 with an EUP6 more straightforward can be found in the troubleshooting section of the website. This is also contained within the EUPFK fitting/conversion kit.

News Archive

All prices shown on this website are in GBP Sterling (£). For any orders from outside the UK please contact Morco Products Ltd for a quote.

Registered Address: Morco Products Ltd, Morco House, Riverview Road, Beverley, East Yorkshire, HU17 0LD

Sales Hotline - 01482 325 456
Fax Hotline - 01482 212 869