The EUP11RSVERT is the equivalent to the F11EL. It is EUP compliant with the same power output as the F11EL. It has electronic ignition and is a room sealed, fan flued water heater which means it can be installed in a wide range of locations.
The flues and fitting kits for this new heater are different from those used on the F11EL. The EUP11RSVERT can only be flued vertically using the RSF045 flue. This cannot be adapted in the field to fit a horizontal flue. The fitting kit required is the PKE.
A conversion document to make the replacement of an F11EL with an EUP11RSVERT more straightforward is contained within the fitting/conversion kit. This can also be found in the downloads section below.
The flues and fitting kits for this new heater are different from those used on the F11EL. The EUP11RSVERT can only be flued vertically using the RSF045 flue. This cannot be adapted in the field to fit a horizontal flue. The fitting kit required is the PKE.
A conversion document to make the replacement of an F11EL with an EUP11RSVERT more straightforward is contained within the fitting/conversion kit. This can also be found in the downloads section below.
Flow rate: 8 Litres per minute approx. at 35 degree temperature rise
Dimensions: H 658 W 304 D 238
Fully EuP compliant
Gas Type: LPG
Room Sealed
Fan flued
Can only be flued vertically (RSF045) – for a horizontally flued appliance please see the EUP11RS
Electronic ignition
Mains electricity required
Can be used on a 12v system with a small inverter
Must be fitted by a Gas Safe registered engineer
Dimensions: H 658 W 304 D 238
Fully EuP compliant
Gas Type: LPG
Room Sealed
Fan flued
Can only be flued vertically (RSF045) – for a horizontally flued appliance please see the EUP11RS
Electronic ignition
Mains electricity required
Can be used on a 12v system with a small inverter
Must be fitted by a Gas Safe registered engineer
